WC-CoCr

how can we help you?

Contact us at ENDURANCE WEAR SOLUTIONS LLP.

WCCoCr Tungsten Carbide Coatings in Mumbai

  • HVOF and HVAF 86/10/4 WCCoCr coatings are used for deposition of wear resistant coatings which have Excellent resistance to sliding wear, cavitation, abrasion and erosion.
  • HVAF TC Coatings have high fracture toughness coefficient and offer good fatigue and impact resistance.
  • HVAF and HVOF WCCoCr coatings have good corrosion resistance except in high PH environment and in the presence of hydro fluoric acid solutions.

HVAF Tungsten Carbide coatings are gas tight (non – permeable to gas and liquid) starting from 50 microns thickness.

Composition

Nominal composition wt.%
Tungsten Carbide Base
Total Carbon 5.3 – 5.4
Cobalt 9.5 – 10.4
Chromium 4.0 – 5.0

Properties

Property / Kermetico HVAF Spray Mode Economy Balanced Ultra – Quality
Deposit efficiency, % 65+ 48-58 36-42
Hardness, HV300 1,050-1,250 1,250-1,1,350 1,350-1,600+
Apparent metallographic porosity <0.8 <0.5 <0.3
Bond strength (@0.040″ thickness) Mpa (PSI) 80+(12,000+)
Typical as-sprayed roughness, micro-inch 80-130
Lowest as-sprayed roughness micro-inch N/A 40 40
Maximum working temperature, oF (oC) 950(510)
micrograph of tungsten carb

Micrograph of Tungsten Carbide Coating Sprayed by Endurance Wear Coatings, Mumbai

Typical Applications for TC Coatings in India

  • Pump impellers
  • Hydro turbine components.
  • Needle valves.
  • Wire drawing capstones.
  • Bridle roll in steel galvanising.
  • Hydraulic rods.
HVAF and HVOF TC Coatings

In recent years, HVOF-sprayed WC-Based coatings have been successfully applied on metal alloy hydro-turbine components to combat cavitation and sand slutty erosion.

However, the WC phase in the coatings partially decomposes into w2c or even w when the traditional HVOF thermal spray technologies are used. IT embrittles the coatings and eventually deteriorates their performance.

High velocity ( at almost 1000 m/s can be achieved) Air fuel system which operates at much lower combustion temperature ( warmer than cold spray and cooler than HVOF) using gas or liquid fuel and compressed air ( no oxygen) for combustion.

The Wc-based coatings can greatly decrease the degree of decarburization of Wc or Cr3C2 as result of much lower flame temperature.

It was found at such coatings by HVAF spraying method exhibited higher hardness and sliding wear resistance compared to the one applied with HVOF.

With the HVAF combustion temperature below 2,000oC (3,632°F), the surface temperature of cobalt, nickel and iron alloy particles usually remains near their melting point.

Wang et al, have also found that the hvaf-sprayed wc-10Co-4Cr coating exhibited higher sliding and abrasive resistance and well as higher corrosion resistances than counterpart coatings deposited by gas/liquid fuelled HVOF systems.

Endurance Wear Solutions Llp thermal spray HVOF and HVAF WCCoCr coatings at our shop in Mumbai, Maharashtra, India. Call us or send an inquiry to get our best price.